AMX NXD-700Vi manual Installation, Installing the No-Button Trim Ring

Installation

Installation

NXD-700Vi panels are installed into either a pre-wall surface (using a CB-TP7 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).

It is recommended that if you are planning on upgrading your flash memory, you do so before beginning any panel installations.

Installing the No-Button Trim Ring

The NXD-700Vi panel is shipped from AMX with the default Button Trim Ring already installed. The unit is also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring) that allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with no-button openings. In order to install this included No-Button Trim Ring, you must first remove the factory-installed default Button Trim Ring, the six small buttons, and associated two clear light pipes.

1.The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2.Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 7).

3.In a single motion, press down and then outwards on the three Trim Ring latches located along the top of the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the Internal Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the Internal Faceplate.

4.Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it from the Faceplate (FIG. 7).

Trim

Ring

Latches

Default Button Trim Ring (with button openings)

Faceplate (outside surface shown)

NXD-700Vi Panel/enclosure

Button latch

Light Pipe latch (black)

Button and Light Pipe removal

(showing the internal surface of Faceplate)

FIG. 7 Removing the default Button Trim Ring

7" Modero Widescreen Touch Panels 13