AMX NXD-700Vi manual Installation and Upgrade of the Internal NXD Components

Installation and Upgrade of the Internal NXD Components

Installation and Upgrade of the Internal NXD Components

Upgrading the cards within the WallMount panel involves removing the rear plastic outer housing (back box), removing the existing card, replacing it, and then placing the back box back onto the NXD panel, as described in the following sections.

Step 1: Remove the existing NXD Outer Housing

1.Carefully detach all connectors from the side of the touch panel and remove the Faceplate from the front of the panel.

2.Place the LCD facedown on a soft cloth to expose the under-side of the unit (FIG. 3). This step helps prevent scratching of the LCD.

Two (2) connector overlay release latches

Unscrew these four pan-head housing screws to remove the back box (2 per side)

FIG. 3 Location of the attachment screws and connector overlay release latches on an NXD back box

3.Firmly press down on both connector overlay release latches (located in front of the connectors). Pressing down releases the connector overlay from atop the connectors.

The overlay connector must first be released before the rear back box can be removed from the NXD-CV7/NXD-700Vi panel.

4.Gently slide the connector overlay away from the back box housing.

5.Unscrew the outer housing (back box) by using a grounded Phillips-head screwdriver to remove the two sets of pan-head Housing Screws, located on both sides of the housing (FIG. 3).

7" Modero Widescreen Touch Panels 9