AMX NXD-700Vi manual Install the new Compact Flash Memory card

Installation and Upgrade of the Internal NXD Components

Connector Overlay must first be removed from the side of the NXD

Wireless CF card (Slot #2 is located on the top slot)

FIG. 4 Location of the wireless CF card connector on main board

6.Carefully lift-off the back box housing and angle it over to the side of the unit where the wires are connected to the circuit board.

7.Gently lay the back box to one side of the unit. This exposes the internal circuit board (FIG. 4). Take care not to place undue strain on the speaker cables.

Step 2: Install the new Compact Flash Memory card

1.Discharge any static electricity from your body by touching a grounded metal object and then locate the existing 128 MB Compact Flash card on the main board (FIG. 5).

Compact Flash	Wireless CF Card
Memory Card (Slot 1)	(Slot 2)
Card Removal Grooves	Card removal grooves

FIG. 5 Location and orientation of the card slots

2.Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the existing card), and gently pry the card out of the slot (FIG. 6). Repeat this process on the opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board connector pins.

3.Grip the old card by its sides and then carefully pull it out of the slot.

4.Remove the new CF memory card from it’s anti-static bag.

5.Grip the sides of the new CF memory card and firmly insert it into slot opening (with the arrow facing towards the pins) until the contact pins are completely inside the flash card and it is then securely attached to the pin sockets.

10 7" Modero Widescreen Touch Panels