AMX NXD-700Vi manual Calibration page actually 3 separate screens

Firmware Pages and Descriptions

Calibration Page

This page (FIG. 76) allows you to calibrate the touch panel using a pre-selected touch driver.

Press and hold the grey Front Setup Access button (below the Modero LCD) for 6 seconds to access the Calibration page.

Press the crosshairs to calibrate the panel and return to the last active firmware page.

The request to touch the crosshairs is the first on-screen message

Calibration successful is the second on-screen message that appears after the calibration process is completed

On-screen crosshairs used for calibration of the touch device

FIG. 76 Calibration page (actually 3 separate screens)

If the calibration was improperly set and you cannot return to the Calibration page (through the panel’s firmware); you can access this firmware page via

G4 WebControl where you can navigate to the Protected Setup page and press the Calibrate button through your VNC window.

This action causes the panel to go to the Calibration page seen above, where you can physically recalibrate the actual touch panel again using the above procedures.

7" Modero Widescreen Touch Panels 99