Connect the base unit | Uniden EXAI 7980 specification

Step 2 (continued)

Connect the base unit

If you want to install the base unit on the wall, see page 45.

Route the cord.

2

To AC outlet

To DC IN 9V

1

AC adapter (supplied)

To telephone outlet

Telephone line cord (supplied)

To TEL LINE

3

1 Connect the telephone line cord to the

TEL LINE jack and to a telephone outlet.

Note Until the handset battery is fully charged, you can only answer incoming calls at the base unit.

2 Connect the AC adapter to the

DC IN 9V jack and to a standard 120VAC wall outlet.

3 Set the base unit on a desk or tabletop and place the handset on the base unit.

Then raise the antenna to a vertical position.

Note

Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical hazard.

7

Image 7

Uniden EXAI 7980 owner manual Connect the base unit

Contents

Exai Introduction Features Table of contents 11 to Read this first6 to 9 to10 Step Checking the package contents Choose the best location Setting up the base unit Connect the base unit Tips Choose the dialing mode Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Setting Caller ID options Entering your area code On-hook dialing Making calls Off-hook dialing On-hook redialing RedialingOff-hook redialing Receiving calls Auto Talk when ringingAny key when ringing Any key when paging Handset ringer tone Handset ear speaker volume Base speaker volume Base ringer switchReceiving a call from the base Storing phone numbers and names Memory storing Dn »key to scroll through the characters Making calls with memory dialing Memory dialingOn-hook dialing Display a Programmed Number Off-hook dialing Editing a stored name and/or phone number Memory editing Use the #/ 1 and */tone/0 Erasing a stored name and/or phone number Memory erasing Caller ID Caller ID service Here are some typical displays When the telephone rings Viewing the Caller ID Message list Long Distance call settings and cancellation Deleting a Caller ID message Deleting information from the Caller ID list Deleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Setting the clock Using the answering machine Changing the greeting Recording the greeting Turning the answering machine on and off Setting the number of rings Setting maximum recording time for incoming messages Setting the toll saver switch Playing recorded messages Screening incoming calls Deleting recorded messages Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor Way conversation When speaking on the handsetWhen speaking on the base Additional information Changing the digital security code Standard wall plate mounting Mounting the base unit on a wall Direct wall plate mounting Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure Symptom Suggestion Troubleshooting Additional information Handset SpecificationsGeneral Base unit W, X, Y, Z IndexG, H K, LPage Uniden America Corporation