note

Only the last number dialed can be accessed after the selected line key has been pressed.

note

The tone feature only applies when the dial mode is set to pulse.

Redial from Talk Mode

1)Press line1.

2)Press redial/pause.

The last number dialed will be displayed and redialed.

3)To hang up, press the select line key or place the handset on the base. The call-time will be displayed for about 5 seconds.

From the Base

1)To call the last number dialed from the base, press line 1.

2)Press redial/pause. The last number dialed from the base is redialed.

3)To hang up, press the selected line key.

Tone Dialing Switch-over

Some telephone companies use equipment that require pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, you can switch-over to tone dialing during the call. An example of this could be entering your bank account number after you have called your bank. The digits of your bank account can be entered using DTMF tones.

Initially make your call with the pulse dialing mode. Once your call connects, press * /t/tone for the handset, or * /tone for the base. Enter the desired number (like in example above the bank account number). These digits will be sent as tone dialing. This special number can be stored in a memory location. This is referred to as Chain Dialing (See page 31). Once the call ends, the tone mode is canceled and pulse dialing mode resumes.

[ 16 ] B A S I C S

Page 20
Image 20
Uniden TRU3466 owner manual Tone Dialing Switch-over, Redial from Talk Mode, From the Base