![](/images/new-backgrounds/1257708/25770855x1.webp)
Using Priority Scan
You can program one Priority Channel in each
of the first 10 banks. During Priority Scanning, your scanner checks these special channels
every two seconds, whether or not the scanner has located an active channel.
To activate Priority Scanning:
11 12 13
Press 4(OSCAN) 6) @ @
14 15 18
(OIlAN~ @ @ @
0 ~ ~7 ~18~19~
~ ~ ~ ~
8FT 20
880@@
1112 13
(OSCAN) 6) @ @
14 15 18
(OIlAN~ @ @ @
BSAVE
E3 (3 07 @18@19
Press
§'EJ dFT(§)2O@
The scanner begins normal scanning, but if it detects a signal on a priority channel, it remains on that channel until the signal ends. See "Using Scan Delay" on Page 25.
lANK 1 U ~$it
SCAN
888SCAN
lANK li~l. 51
SCAN PRI
P ~ ~ 120.500 11Hz
12.5KHz All
Note: I~you have more than one bank selected that has a programmed priority channel, the lower channel number has top priority .
Data Skip is not active in this mode.
Selecting A New Priority Channel
There is one priority channel in each of the first 10 banks. The scanner is
channel to be any other channel within the bank.
Note: When you select a new priority channel, the old priority channel automatically becomes a regular channel.
1.Enter the Manual Mode.
~1112 13
(OSCAN) 0 @ @
14 15 16
Press 4(OIlAN~ @ @ @
a ~ ~7 ~18~19
a~e;~~
8FT 20
B80@@
24