-
6. Press [E] to store the entry.
. If the frequency is already stored in another channel, the other channel will appear on the display. To resolve the conflict, just enter another frequency for the cu"ently selected channel. (Later, we'll discuss how to delete a stored frequency.)
. Any frequency already stored in a channel will automatically be replaced by the new one.
. "Error" appears on the display if an e"or is made during programming, or if the frequency is out of range. To clear the error, enter a valid channel or frequency number.
To program another channel, repeat the above procedures.
B.ProgrammingWith the Rotary Tuner
To program a channel using the Rotary Tuner:
1. If the UBC 2500XLT is scanning, press [MANUAL] to I stop scanning.
2.Select a channel to be programmed by turning the Rotary Tuner to display the channel. (Rotate the control clockwise to step up a channel, or counterclockwise to step down a channel.)
Note: If theChanneVFrequency/LockSelector[CIFIL] . is set to ilL"(lock), turn the control to "C" to enable channel selection using the Rotary Tuner.
3.Turn the Channel/Frequency/Lock Selector to "F" to enable frequency selection.
4.Select a frequency to be stored by turning the Rotary Tunerto display the frequency. (Rotate the control clockwise to step up a frequency, or counterclockwise to step down a frequency.)
Note: When you rotate the Rotary Tuner, the channel selection flashes on the display. This means that the frequency displayed is not programmed in that channel.
5.To store the displayed frequency into the current channel, continue with Step 6
To store the displayed frequency into another
selected channel, skip to Step 7
To store the displayed frequency into another bank's
open (empty) channel, skip to Step 10.
17
