Controls and Indicators, TopView | Uniden USC 2500XL T specification

Controls and Indicators

TopView

EmmalChannel!

SpeakerFrequencyl

Lock

Earphone

I

Antenna

OriOlfRotary

VolumeTuner

Connec1Dr

Squelch

EXTERNAL When using an optional External Speaker

SPEAKERJACK system, connect the External Speaker plug here.

EARPHONE	Plug the earphone into this jack for private
JACK	listening.	When the	earphone is connected,
	the internal speaker is disconnected.
ANTENNA	Connect	the rubber	antenna	to this	BNC
CONNECTOR	connector	and turn	clockwise	until	it locks.

ON-OFFNOLUME(Inner control) This control turns the scanner

CONTROL on or off, and also adjusts the volume.

SQUELCH CONTROL

(Outer control) Adjust the outer control to set the scan threshold. When monitoring a

single channel in Manual Mode, adjust the Squelch Control to eliminate the background rushing noise heard in the absence of an incoming signal.

CHANNEL! (Outer control) Turn the [CIFIL] Selector to FREQUENCY! "C" to enable channel selection, or to "P' to

LOCK SELECTORenable frequency selection. In the "L"

position, the Rotary Tuner is disabled, and cannot be used to select (display) channels

or frequencies.

VFOCONTROL (Inner control) Use the Rotary Tuner to (ROTARYTUNER)select a channel or frequency. Turn the

control clockwise to STEP UP, or counter- clockwise to STEP DOWN, a channel or frequency.

5

Image 7

Uniden USC 2500XL T manual Controls and Indicators, TopView

Contents

USC 2500XL T This equipment contains a Nickel-Cadmium Precautions Table of Contents About Your New UBC 2500XLT Leather-like Carrying Case Unpacking Auto Store Automatically stores all active frequencies Weather Channels Lets your scanner function as aAustralia TopView Controls and Indicators FrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM Ikeylocki Setup Mounting the Flexible Antenna Installing the Belt Clip Bank Scan If you have programmed channels, you Scanning OverviewBand Search The Search function is different from 0 5 Programming ChannelsThen, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency HLD to stay on that frequency Ress Manual to stop scanningExample Set search limits of 137.000 to 144.000 MHz Press SRC to start the search 4 0 0 Press LMT Auto Store feature automatically stores all activePress Manual to stop scanning First enter the lower limit by pressing Display. In this case, select another bank ~nother Open Channel Press E Current channel is erased, and the display shows Deleting a Stored Frequency Press Manual again Scann ing Weather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan Mode Setting Up Priority Channels To activate the Count feature Using Count to Monitor Channel Activity Reprogram each channel Care and MaintenanceTurn the scanner off before removing the Battery Pack Event of memory loss. If memory is lost, simply Do not use excessive amounts of water Clean the outside of the scanner with a mild detergent Problem Troubleshooting 137 174 222 400 520 Technical SpecificationsSearch Band Display Warranty Unid~n~GP