Setup | Uniden USC 2500XL T manual

Setup

The UBC 2500XL T comes with a rechargeable Nickel-Cadmium Battery Pack. When fully charged, this Battery Pack will supply up to 5 hours of dependable use.

Before using the UBC 2500XL T for the first time, or whenever the LOW BATTERY Indicator appears on the LCD display, you should fully charge the Battery Pack.

Note: When the Battery Pack is Iow, the Low Battery Indicator will start to blink. After about 10 minutes, the

scanner will shut itself off to prevent the battery from becoming completely discharged.

Before charging, you must first install the Battery Pack

according to the steps below.

I

Installing the Battery Pack

1.Turn the On-OffNolume Control OFF.

2.Slide the pack onto the bottom of the scanner until it clicks.

D

~

Charging the Battery Pack

1.Plug the AC Adaptor ICharger (AAD-2500U) into the Charging Jack located on the back of the Battery Pack.

WARNING! Use only the supplied AC Adaptor/ Charger. Any other AC adaptor or external power plug having over-voltage or reversed polarity can cause overheating or damage to the circuitry.

2.Plug the AC Adaptor /Charger into a standard AC outlet.

13

Image 15

Uniden USC 2500XL T manual Setup

Contents

USC 2500XL T This equipment contains a Nickel-Cadmium Precautions Table of Contents About Your New UBC 2500XLT Leather-like Carrying Case Unpacking Weather Channels Lets your scanner function as a Auto Store Automatically stores all active frequenciesAustralia TopView Controls and Indicators FrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM Ikeylocki Setup Mounting the Flexible Antenna Installing the Belt Clip Scanning Overview Bank Scan If you have programmed channels, youBand Search The Search function is different from Programming Channels 0 5Then, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency HLD to stay on that frequency Ress Manual to stop scanningExample Set search limits of 137.000 to 144.000 MHz Press SRC to start the search 4 0 0 Press LMT Auto Store feature automatically stores all activePress Manual to stop scanning First enter the lower limit by pressing Display. In this case, select another bank ~nother Open Channel Press E Current channel is erased, and the display shows Deleting a Stored Frequency Press Manual again Scann ing Weather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan Mode Setting Up Priority Channels To activate the Count feature Using Count to Monitor Channel Activity Reprogram each channel Care and MaintenanceTurn the scanner off before removing the Battery Pack Event of memory loss. If memory is lost, simply Do not use excessive amounts of water Clean the outside of the scanner with a mild detergent Problem Troubleshooting 137 174 222 400 520 Technical SpecificationsSearch Band Display Warranty Unid~n~GP