LCD DISPLAY
SCAN KEY
The liquid crystal display (LCD) shows the current channel and frequency. It also
displays the mode, status, and bank indicators.
Press [SCAN] to start scanning all programmed channels that are not locked out. ("SCAN" appears on the display during scanning.)
MANUAL KEY In Scan or Search Mode, press [MANUAL] I to stop scanning or searching, and to select a channel. After you stop the scanner, press fMANUAL] again to STEP UP a channel or requency. Press and holdto rapidly step through the channels or frequencies. Use
the numeric keypad to enter a channel
number, and then press [MANUAL] to access the channel.
WX KEY There are 7 weather channels. Press
[WX]to find the active weather
channel in your area. ('WX' appears on the display in Weather Mode.)
Note: Currently the Weather Service is not available in Australia.
DELAY KEY
UO KEY
PRI KEY
Use [DL V] to turn ON or OFF the automatic
for active frequencies. (In Delay Mode, "DLY" appears on the display.) In this mode, when
the scanner monitors an active frequency, searching or scanning will not resume until transmission stops for 2 seconds.
Press rUe] to "lock out" or prevent scanning
of the displaxed channel, including Priority Channels. ('ud' appears on the display.) To
unlock a channel, press rUe] again. rUe] can be used in Manual Mode, or Scan Mode, only on programmed channels. To display locked out channels, turn the Rotary Tuner,
or press [HLD], [LMT], [MANUAL] to manually step through the selected bank. (Note: Locking
out a channel will not erase the programmed
frequency.)
You can assign "priority" to one channel in each of Banks 1 through 10. To assign priority, first display the selected channel, and then press and hold [PRI] for more than
2.5seconds. A "P" appears on the display beside the Priority Channel. In Priority Mode, the scanner monitors the Priority Channel(s) every 2 seconds. If activity is detected, the
scanner monitors that channel until no signal is present. ("PRt' appears on the display.)
7
