~ramming With SEARCH

'ch feature enables you to rapidly search for active jes within the specified band limits. When an

Ig frequency is found, you can store it into a channel t procedure below.

ress [MANUAL] to stop scanning.

Jse the numeric keypad to enter the lower limit and Ipper limit of the band to be searched. (See "Technical 3pecifications" for a list of search bands.)

Note: When you first use the scanner, you must set the search limits before activating SEARCH. Other-

wise, when you try to start SEARCH, error tones are emitted and "Error" appears on the display.

Example: Set search limits of 137.000 to 144.000 MHz.

FIrst enter the lower limit by pressing:

[1] [3] [7] [.] [0] [0] [0]

I'

Press[LMT].

Then enter the upper limit by pressing:

[1][4] [4] [.] [0] [0] [0] Press[LMT].

The search limits of the selected band are now set, and remain in effect even when you turn off the scanner.

3.Press [SRC] to start the search.

Note: During the search, you can manually change the

step increment, if desired. To change the step, press

[STP]one time for each selection: 5 kHz, 12.5 kHz,

25 kHz, or 50 kHz, or press [.] twice to reset to default.

4.When Search stops on an interesting frequency, press

[HLD] to stay on that frequency.

Note: If you press [HLD] again, you step up a frequency. If you press [LMT], you step down a frequency. Press and hold either key to rapidly step through the frequencies.

19

Page 21
Image 21
Uniden USC 2500XL T manual Ress Manual to stop scanning, Example Set search limits of 137.000 to 144.000 MHz