VDO Dayton VDOdayton, CD1537x, CD 1737x manual Installation

Cleaning the unit

Do not clean using cleaning fluid, alcohol or other solvents. Use only a damp cloth.

CD-R/CD-RW discs

zWhen CD-R/CD-RW discs are used, playback is possible only for discs which have been finalized.

zIt may not be possible to play back CD-R/CD- RW discs recorded on a music CD recorder or a personal computer because of disc charac- teristics, scratches or dirt on the disc, or dirt, condensation, etc., on the lens of this unit.

zPlayback of discs recorded on a personal computer may not be possible, depending on the application settings and the environment. Please record with the correct format. (For details, contact the manufacturer of the appli- cation.)

zPlayback of CD-R/CD-RW discs may become impossible in case of direct exposure to sun- light, high temperatures, or the storage condi- tions in the vehicle.

zTitles and other text information recorded on a CD-R/CD-RW disc may not be displayed by this unit (in the case of audio data (CD-DA)).

zRead the precautions with CD-R/CD-RW discs before using them.

INSTALLATION

Use the supplied mounting sleeve and the strap bracket to mount the car radio firmly in the dashboard.

Only use the supplied screws and nets for installation.

Keep leftover installation equipment for future use.

If the installation requires drilling of holes or other modifications to the vehicle, contact your nearest dealer.

This set is designed for the installation in the radio space in the dashboard.

Installation

1.If the space is to small, enlarge it as shown in figure F.

2.Install the sleeve in the dashboard (see fig- ure G).

z Slide the sleeve in the dashboard.

z Push the tabs down with a screw driver.

3.Insert the radio into the sleeve.

4.Connect the cables as shown in figure C.

5.Attach the bracket to the radio and mount it an the chassis (see figure H).

Connection in vehicles equipped with standard ISO connectors

The radio may be installed without major prepa- ration in vehicles equipped with ISO connec- tors. Some signals may have to be adapted or connected to the ISO connectors.

Connection in vehicles without standard ISO connectors

For vehicles with different connection require- ment, ask your dealer for an adaptor cable. If no adaptor cable is available for your vehicle, connect the radio as describe in the "Connec- tors" section.

Preparation

The device must be connected to a 12V DC electrical system with a negative terminal to earth (car chassis).

Warning: Installation that does not con- form to these requirements may result in malfunction, damage or fire!

To avoid the risk of a short circuit during instal- lation, disconnect the negative terminal of the battery until the set has been securely installed and connected.

Connectors (fig. C)

Connector A 1)

a- Power Supply

1Yellow/red wire A4: Connect to the switched 12V supply (switched on/off by the car igni- tion.

2Red wire A7: Connect to a permanent 12V supply. This is the main power supply. Ensure that this connection can handle a current of 15A.

3Brown wire A8: Connect to earth (car chas- sis).

Electronic or Motorised Antenna

Connect pin A5 to the power supply for an electronic antenna or the control wire for the relay of an automatic motorised antenna.

Do not use this connection for direct power supply to the antenna motor.

12