Radiance Direct Vent Gas Heater
2.Install the rear log by plac- ing it on the ember bed toward the back of the firebox. (Fig. 48) The log should touch the back wall of the firebox. When the log is in place, the two (2) notches on the bottom of the log rest on the two (2) ribs on the back side of the ember bed. (Fig. 49)
Rear Log
Figure 48
LG488
Ribs for Rear Log
Figure 49 | Ember Bed |
|
LG487
Rib and Flat Spot
Rib Flat Spot forfor Front Right Log
Front Left Log
3.Install the front left and right logs (Fig. 50) by placing them on the ribs shown in Figure 49. Make sure the logs line up with the flat spots on the ember bed intended for location purposes. (Fig. 49)
4.Install the left cross log by engag- ing the hole on the bottom with the pin on the left side of the rear log. Set front side of cross log on notch in ember bed. (Fig. 51)
5.Install the right cross log by engaging the hole on the bottom with the pin on the right side of the rear log. Set front edge of cross log on ember bed as shown in Figure 51.
Figure 50
LG489
Front Right Log
Front Left Log
2626 | 20012697 |
