OPERATION

CONNECTING THE PUMP SUCTION LINE
IMPORTANT

TIGHTEN UNIONS BEFORE

INSTALLING UNIT INTO SPA

 

HEATER

 

CONTROL

UNION

PACK

 

"O"-RING TIED TO PIPE FOR SHIPPING ONLY

MOTOR

SUCTION

PIPEPUMP

"O"-RING

REMOVE O-RING TIED TO PIPE FOR SHIPPING AND INSTALL THE "O"-RING INTO THE GROOVE ON THE UNION OF THE SUCTION PIPE UNION. MATE THE UNION TO THE PUMP AND ROTATE CLOCKWISE UNTIL SNUG. HAND TIGHT ONLY.

PRIMING THE PUMP

1.Fill the Voyager till the water is approximate- ly 4” over the jets. Do not overfill.

2.Remove the

access door from the module and locate the priming hose system.

3.Remove the valve cap.

Note: the priming valve has an open (inline), closed (across) valve handle.

4.Attach by threading onto the priming valve the male to male hose adapter.5.Connect your garden hose to the adapter.6.Open priming valve (inline position) and start the water flow from your hose.

7.Plug in the voyager GFCI protected cord and follow start up and programming directions.

8.Once the pump “starts” and you note a con- tinuous flow of water at the jets-the Voyager priming phase is complete.

9.Shut off water to hose.10.Close (across position) prime valve handle.11.Replace valve cap.12.Store for future use the adapter.TESTING THE GFCI

Plug in the Ground Fault Circuit Interrupter (GFCI) into a standard 110V-15A outlet (See correct type of outlets on page 5 ).Now is a good time to test the GFCI. Please do so as follows:

The GFCI is a very important safety device. The GFCI shuts off the electricity in a fraction of a second if there is a short anywhere in the system. The GFCI plug fits conventional 110V

outlets. It is recommended that the GFCI be tested prior to each use. Test as follows:

REMINDER: DO NOT USE AN EXTENSION CORD. DOING SO MAY CAUSE DAMAGE THAT WILL NOT BE COVERED UNDER THE WARRANTY.

 

TOP SIDE DIGITAL CONTROL

JET BUTTON:

VOYAGER LV15 TOP SIDE CONTROL

 

Controls Hydro jets

•Low Speed

•High Speed

LED DISPLAY

• Off

 

 

Shows Time

 

 

 

 

 

and Temperature

HEAT

AM

 

 

PM

PROGRAM "PROG" BUTTON

 

 

 

• Switches Display From Time

PROG

 

To Temperature and Vice Versa

 

 

•Initiates Temperature and Time Settings if Held Down For 5 Seconds

See Next Page For Instructions

UP BUTTON

•Raises Temperature

•Forwards Time

•Reverts to Factory Defaults (Temperature = 102°F - Time = 12PM) If Held Down For 5 Seconds

AM/PM DOWN BUTTON Indicator

•Lowers Temperature

•Sets Back Time

•Re-Boots System

If Held Down For 5 Seconds

PAGE 10