ASSEMBLY INSTRUCTIONS

1. PLACE BOTTOM PAD on a clean, smooth, level surface.

Please see SITE SELECTION: Structure on page 4.

2. STRETCH OUT LINER. If liner is stiff, warm in the sun.
3. SET UP WALLS and install locking pins.
4. INSTALL THE LINER

a) Note that the liner has a patterned side. Place the liner so that

the patterned side faces the inside of the spa .

b) Note that the therapy module, the liner seam, the belt spindles,

and the seat with the punched hole, need to be aligned for the

therapy module to cover the seam and the belt spindles and for

the cover straps to fall in the center of the wall sections. All seats

have a knockout whole. Use a screwdriver to remove the hole

cap in the seat that will be located under the therapy module.

c) Choose location of the therapy module, taking into

consideration accessibility and electrical requirements. Refer to

SITE SELECTION on page 4.

1

PIN

SEAT ASSEMBLY

SPA WALLS

3

4a

LOOKING DOWN

d) Place the liner seam in the center of the wall section you would

like to put the therapy module on.

e) Stretch the liner over the top rim of the spa. Stretching the liner

into its final position will take about five minutes and may require

three or more persons.

5. INSTALL THE TOP BAND locating the belt spindle at the

liner seam. Inline with only the seat suction hole.

BELT

TO TIGHTEN AND TURN

USE 3/8" BOX WRENCH

4b

WALL SECTION

BENCH

ALIGN

BENCH

TO WALLS

KNOCK-OUT HOLE WHERE THERAPY MODULE SUCTION IS TO BE INSTALLED

SPINDLE

BOLT

5

SEAM LOCATION

6.INSERT THE SEATS, aligning the seat with the punched hole with the liner seam. To assist in the installation of the seats, it may be necessary to position 2 seats like a pyramid (see diagram

below). Gently press down on the apex and they will all register in

6

place.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PAGE 6