E. Filtration Cycles

Your spa digital control has an electronic timer that has been pre-programmed to automatically run the filtration low speed pump 3 hours twice a day for a total of 6 hours, from 8am to 11am, and from 4pm to 7pm. The heater will come on as needed during those hours. Note that filtration will also be provided during the heating cycles, when the spa electronic thermostat starts the low speed pump and the heater to maintain the desired temperature.

F. Memory

The temperature setting that is entered into your spa digital topside control are permanently retained in its solid state memory. In the event of a power failure, the temperature setting will be captured and held until power returns. The temperature setting at the time of the power failure will be restored when power returns.

G. Resetting Your Spa

Like your PC at home, your spa electronics could get corrupted by electrical surges or other interference resulting in improper operations. To properly reset or reboot your spa, unplug the GFCI and plug it back in after 5 full minutes. Then press and hold the “UP” arrow button for 5 seconds. The topside display will show 12:00 PM as soon as you release the “UP” button and the temperature will be reset to 102ºF, indicating a successful system reset.

AIR CONTROL OPERATION

AIR CONTROL OPERATION -Open to regulate air to jets. When finished with spa, return pump to low speed. Close so air induction does not fight the heater.

JET LAYOUT / USE / ADJUSTMENT - All jets have flow control “dial” adjustment. By rotating the jet face, changing the combination of jets, and adjusting to what extent they are open or closed, you have the ability to “customize” each bank of jets to your individual hydro-massage needs of flow and pressure.

Directions for increasing flow through jets.

Open Closed

Remember, as you turn off or reduce the flow of water out of one jet, you also increase the pressure and flow through the others. An important feature of this jet adjustment ability, is to enhance specific water currents in the Voyager Spa. For example, if you shut off one entire bank or jet side of the module and open the other, you can create a “true” whirlpool effect in the spa within a few minutes.

Remember that the Voyager has a 2 speed pump. You can further vary the massage and water current sensations by changing speeds which changes the amount of water flow through the jets.

This is also true of the air control / jet relationship.

IMPORTANT: Always leave at least 2 jets on or opened so that the pump is not back-pressured. When finished with the use of the spa, put the pump into low speed and close the air control.

Directional jet eyes can be positioned as desired.

PAGE 12