VII. LACK OF PRESSURE AT ONE OR SEVERAL OF THE JETS

Cause:

Jet(s) could be closed.

Solution:

Open jet(s). The flow of the jets is controlled by the jet finger ring. Adjust the ring to direct the water to the desired jets. See instructions on page 12.

Cause:

Obstruction in plumbing.

Solution:

Remove the jet face(s), clean and re-install. See section on HYDROTHERAPY JETS. If any of the above does not solve the problem, (page 12) call Service Center and mention code "LOW FLOW-1"

IX. THERAPY MODULE LEAKS

Cause:

Loose union(s) at the pump.

Solution:

Unplug the module. Remove door to the unions. Hand tighten. Do not use pliers. If the leak is anywhere else, call Service Center for assistance.

X.WATER LEAK THROUGH THE LINER

Cause:

Puncture of the liner.

Solution:

Patch the hole using a vinyl patch kit. A vinyl patch kit can be obtain at your retailer or by calling the Service Center. In the unlikely event that the leak is at the seam, call the Service Center to order your replacement liner.

XI. WATER NOT CLEAR

Cause:

Dirty filter cartridge.

Solution:

Clean or replace the cartridge.

Cause:

Improper water chemistry.

Solution:

See "Balancing your spa water" and "Water Maintenance" sections on page 13-15.

Cause:

High content of solid in water.

Solution:

Use clarifier or drain and refill the spa.SERVICE CENTER

Your Voyager Therapy Module has been designed to minimize service requirements. There are no user serviceable parts in the module.

9am - 5pm Mon.-Fri. EST Toll Free: (877) 240-9457 or (305) 908-8187

Fax: (305) 685-9794 e-mail: voyager@dmindustries.com Attn: Voyager Service Center

Do not try to service the module or the GFCI. If you have an operation problem, go carefully through the troubleshooting steps outlined in the troubleshooting section of this manual. If you cannot correct the problem, contact DM Industries Ltd.'s Service Center for assistance or for the nearest Service Center to you.

PAGE 22