FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
5.Lift up on the door assembly and swing the right side out then move the assembly to the left to clear the slots in the upper door sill.
6.Lay the door assembly on a flat cushioned surface for disassembly.
7.Reverse procedure to install door assembly and check for proper adjustment as outlined under "DOOR ADJUSTMENT", "DOOR CHAIN ADJUSTMENT (SIMULTANEOUS DOORS)" and "DOOR SWITCH ADJUSTMENT" in
"SERVICE PROCEDURES AND ADJUSTMENTS".
Disassembly
1.Remove the door assembly as outlined in "OVEN DOORS (SIMULTANEOUS)" under
"ASSEMBLY REMOVAL".
2.Remove the door chain by loosening one of the turnbuckles.
3.Loosen the set screw on the sprocket of door being replaced.
4.Drive out the spirol pin from the sprocket of door being replaced.
5.Remove the door from lower sill bearings and sprocket.
A.Door assembly parts are now accessible for inspection and/or replacement if necessary.
6.Reverse procedure to
"SERVICE PROCEDURES AND ADJUSTMENTS".
DOOR CATCH ROLLER
ASSEMBLY
(INDEPENDENT DOORS)
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove the top front cover as outlined under
“COVERS AND PANELS”.
2.Remove the catch roller assembly.
3.Reverse procedure to install.
4.Adjust the catch roller as outlined under
“DOOR CATCH (ROLLER) ADJUSTMENT (INDEPENDENT DOORS)” in “SERVICE PROCEDURES AND ADJUSTMENTS”.
MECHANICAL (KX)
THERMOSTAT
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove the racks and right rack support.
2.Remove the thermostat knob and mounting screws from the control panel and then remove the control panel.
3.Remove the probe guard from the oven cavity wall.
F25105 (December 2001) |
| Page 14 of 60 |
|
