FULL SIZE ELECTRIC CONVECTION OVENS - SERVICE PROCEDURES AND ADJUSTMENTS
DOOR ADJUSTMENT
1.Check the doors to make sure they have an equal gap between them and that the vertical edge of the door is parallel to the vertical door seal. If the doors are not positioned in this manner, adjust the doors as described.
2.Remove the top front cover.
3.Loosen the screws that secure the upper door bearings and related hardware, just enough to allow door movement.
4.Move the door until proper alignment is achieved then tighten the screws on the upper door bearing hardware.
5.Repeat step 3 and 4 on the opposite door, if necessary.
DOOR CATCH ROLLER
ADJUSTMENT
(INDEPENDENT DOORS)
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove the top front cover as outline under "COVERS AND PANELS" in "REMOVAL AND REPLACEMENT OF PARTS".
2.Open the doors and inspect the door strike for proper shape.
A.Replace if bent and adjust as outlined in this procedure.
3.Open and close the doors several times while observing the catch roller operation.
A.Replace if malfunctioning and adjust as outlined in this procedure.
NOTE: Shims may be required under the door strike to raise it, before the proper door tension adjustment can be set.
4.Apply lubricant around the spring. See “LUBRICATION” under “GENERAL”.
5.Close the doors and check them for proper alignment.
A.Doors should be centered and parallel at the top and bottom, in the oven cavity opening. See "DOOR ADJUSTMENT".
F25105 (December 2001) |
| Page 22 of 60 |
|
