Vulcan-Hart VL2GSS, VL3GMS, VL2GMS, VL3GAS, VL2GAS, VL3GSS Gasket, Door Screw Nut, Door and Bushing

VL SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

COMPARTMENT GASKET AND DOOR SCREW NUT, DOOR AND BUSHINGS

Gasket

1.Open the compartment door to be replaced.

2.Remove screws securing the gasket retaining plate to the gasket.

3.Lift the gasket off the inner door plate.

4.Position the new gasket on the inner door plate and reverse procedure to install.

NOTE: Damage to the gasket sealing surface, such as nicks or cuts, will cause steam leakage.

Door Screw Nut

1.Open compartment door to be serviced.

2.Turn screw handle fully clockwise to extend inner door plate assembly.

3.Lift the inner door plate assembly up, until the mounting pins are out of the holes in the pressure bar and set the assembly aside.

4.Turn screw handle fully counterclockwise and remove from door.

5.Remove screws mounting the pressure bar to the backside of the compartment door.

NOTE: A compression spring is mounted behind each screw. Set aside for reuse.

6.Remove screws mounting the door screw nut (bronze) to the backside of the compartment door.

7.Reverse procedure to install and check for proper operation.

Door and Bushing

1.Open the compartment door to be replaced.

2.Remove the right side pan support inside the compartment.

3.Remove the four bolts inside the compartment that secure the block hinges to the exterior side of the compartment.

CAUTION: Door is extremely heavy and will drop when bolts are removed.

4.At this time, the bushings can be replaced if necessary, by removing the bushings from the pin on each block hinge.

5.Reverse procedure to install and check for proper operation.

Page 20 of 88