Assembly Instructions
CHECK BROOM ANGLE ADJUSTMENT
Refer to Angle Adjustment Lever in Operating In-
structions.
CHECK DRIVE CHAIN
Refer to LUBRICATION for Rotary Broom Drive Chain in Maintenance Instructions.
Refer to ADJUSTMENTS of Rotary Broom Drive Chain Tension in Maintenance Instructions.
CHECK GEARBOX
Refer to LUBRICATION for Rotary Broom Gear- box in Maintenance Instructions.
CHECK SIDE TO SIDE LEVEL ADJUSTMENT
Refer to ADJUSTMENTS of Rotary Broom Brush Leveling in Maintenance Instructions.
CHECK BRUSH TO GROUND CONTACT PRESSURE ADJUSTMENT
Refer to Ground Contact Knob in Operating In-
structions.
CHECK CUTTING EDGE
•Make sure the cutting edge is not nicked, bent or worn.
Refer to REPLACING/REPAIRING of
tions.
CHECK AUGER
•Make sure the auger is clear of snow and/or ice.
•Make sure the auger is free to rotate.
•Check that the auger flighting and paddle blades are in good condition and not bent.
CHECK CHUTE AND DEFLECTOR
•Make sure the chute and deflector are not clogged with snow and/or ice.
•Turn the chute rotation handle and rotate the chute. The chute should rotate freely.
•Use the deflector position control knobs and raise and lower the deflector. The deflector should move freely.
CHECK GEARBOX
Refer to LUBRICATION for
CHECK REDUCTION CHAIN
Refer to LUBRICATION for
Refer to ADJUSTMENTS for
Instructions.
Debris Blower
CHECK CHUTE AND DEFLECTOR
•Make sure the chute and deflector are not clogged with leaves and/or debris.
•Turn the chute rotation handle and rotate the chute. The chute should rotate freely.
•Use the deflector position control knob and raise and lower the deflector. The deflector should move freely.
CHECK GAUGE WHEEL TIRE PRESSURE
•Make sure the tire pressure is 20 PSI (137 kPa).
INSPECT DRIVE BELT
Refer to ADJUSTMENTS of Debris Blower Drive Belt Tension in Maintenance Instructions.
CHECK BLOWER FAN
•Make sure the fan is clear of debris.
•Make sure the fan is free to rotate.
•Check that the fan blades are in good condition and not bent.
33
