Assembly Instructions
SETUP INSTRUCTIONS
Walker Implements are shipped partially assem- bled. After uncrating the implement adaptor and/or implement(s), initial setup is required.
NOTE: During the process of unpacking, any dam- aged or missing parts should be noted and reported to the delivering carrier immediately (put in writing within 15 days). The carrier will provide directions for proceeding with a claim to receive compensation for damage.
IMPLEMENT HITCH
Implement Hitch Installation
1.Remove the mower deck from the tractor if nec- essary. Refer to the appropriate Tractor Own- er’s Manual.
2.Lightly grease each tractor support arm (2) on the tractor. Refer to Implement Hitch Installa- tion photo for location of tractor support arms.
3.Engage the hitch frame tube sockets on the tractor support arms. Slide the implement hitch onto the support arms approximately 3 in. (76 mm).
4.Install the hitch pin through the hole on the end of each support arm to lock the hitch in place. Two (2) hitch pins are included in the owner’s packet of materials.
Grease Tractor
Support Arms
Hitch Frame
Tube Sockets
Implement Hitch Installation
IMPORTANT: If the tractor body needs to be raised, the PTO shield must be in the closed or down po- sition and the implement must be in the lowered position. The only time the PTO shield needs to be open or raised is when connecting or disconnecting the driveline for the rotary broom, snowblower, or debris blower.
Hitch Pins Lock Hitch on Support Arms
PTO Shield
in CLOSED
Position
PTO Shield in CLOSED Position
5.Loosen the
3/4 - 10 x 2"
Hex Bolt3/4 - 10 Jam Nut
Implement Hitch Jam Nut Adjustment
IMPORTANT: This adjustment will need to be made only once if the same tractor and hitch are used together. If the hitch will be used on more than one tractor, this adjustment will be required every time the hitch is mounted on a different tractor.
19
