Assembly Instructions
Stand Support
Bracket
Hairpin
Parking Stand
Prepare Rotary Broom for Installation
3.Attach the female broom driveline half (with quick connect yoke) over the male broom driv- eline half. Set the driveline on its support.
NOTE: Driveline sliding surfaces must be greased.
Reduction
Shaft
Drive Shaft
Yoke
Assemble Rotary Broom Driveline
4.Insert the male quick hitch section of the imple- ment hitch into the female quick hitch of the ro- tary broom and place the male quick hitch lever fully forward to the LOCKED position. Secure the male quick hitch latch with the linchpin. Re- fer to Hitch Locking Lever in Operating In- structions.
Male Quick |
|
|
| Female Hitch | |
Hitch |
| |
|
| |
|
|
|
Hitch Locking
Lever
Attach Broom to Implement Hitch
5.Connect the broom driveline to the tractor PTO shaft by sliding back the locking collar on the yoke, then push the yoke over the PTO shaft until the locking collar snaps back fully. Make sure the driveline is well secured at both ends.
DANGER
This shaft turns at very high RPM. If the collar is not locked to the PTO shaft at the tractor end, or if the yoke at the broom end is not secured properly, the driveline can fly loose with great force capable of causing serious injury or death.
|
| Locking Collar |
PTO Shaft | ||
|
|
|
Yoke
Connect Broom Driveline to Tractor PTO Shaft
25
