Wayne-Dalton 341785 installation instructions Operator Bracket, Installation

9	Operator Bracket	u-bar
Tools Needed:	NOTE: If installing a trolley type
Power Drill	operator, complete this step. If not, skip	Side view of u-bar
	this step and continue with step 10.
7/16” Socket
Driver	IMPORTANT: When installing a	1/4”-20 X 7/8” self
	trolley type operator on 9800
		DRILLING screws
	door, a Wayne-Dalton trolley
	bracket must be securely
	attached to the top section. It
	is then unnecessary to further
	reinforce the top section of
	the model 9800 Wayne-Dalton
	door, when attaching a trolley
	type operator, as long as the
	installation of the operator
	is according to Installation
	instructions and owner’s manual
	and force settings are adjusted	Operator
	properly.	bracket

U-bar

Remove, but retain (4-6) 1/4”-20 x 7/8” self drilling screws from the center of the u-bar, allowing the operator bracket to slide between the section and the u-bar.

NOTE: For retro fit applications, the
operator bracket must be aligned with
an existing operator	Top of section
Locate the center of the top section and	Top edge of
	operator
slide operator bracket under u-bar till	bracket
the operator bracket is seated against
the u-bar flange.	U-bar
NOTE: Prior to fastening operator	U-bar
bracket to top section, ensure the top
edge of operator bracket is aligned with	Operator
the top edge of the section as shown on	bracket
far right.	Operator
	bracket
Attach the operator bracket using (6)	Side view of u-bar with
1/4” – 20 x 5/8” self drilling screws (as	Operator bracket installed
shown). Finish re-attaching the u-bar
using the self tapping screws removed
previously.

	( 6) 1/4”-20 X 5/8”
	self drilling
Operator bracket in	screws
place under u-bar
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.	17

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

INSTALLATION