Wayne-Dalton 341785 installation instructions Adjustable Flagangle, Attaching Horizontal Track to

12	Attaching Horizontal Track to
	Adjustable Flagangle
Tools Needed:	NOTE: If quick install flagangle was		flagangle
7/16” Socket	installed in Step 11, skip this step and
	continue with Step 13. If not, complete
Ratchet Wrench	this step.		Stud
	To install horizontal track, place the		plate
7/16” Wrench
	curved end over the top roller. Align
Level	the bottom of the horizontal track with
	the vertical track. Hand tighten the
Flat Tip	horizontal track to the flagangle with
	(1) stud plate and (2) 1/4” - 20 flange
Screwdriver
	hex nuts.
	Level horizontal track and bolt the top
	curve of the low headroom horizontal
	track slot in the flagangle using (1)	1/4”-20 flange
	5/16” washer, (1) 1/4”- 20 track bolt
		hex nuts
	and (1) 1/4”- 20 flange hex nut. Repeat
	for other side.
	NOTE: If an idrive® opener will be
	installed, position horizontal tracks
	slightly above level.
		flagangle	(1) 1/4”- 20 x 9/16”
			track bolt
		(1) 5/16” washer
		(1) 1/4”- 20
		flange
		hex nut
			top curve of
			low headroom
			horizontal track
20	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com