Wayne-Dalton 341785 installation instructions End Brackets, Center Bearing Bracket

14	End Brackets
Tools Needed:	NOTE: Right and left hand is always
Power Drill	determined from inside the garage
	looking out.
7/16” Socket	End bearing brackets are right and left.
Driver
	Align bottom edge of left end bracket
	with the top edge of the flagangle.
	Maintaining this alignment, also align
	the right edge of the end bracket with
	the right edge of the flagangle.
	Secure end bracket to the jamb using
	(3) 5/16” x 1-5/8” lag screws as shown.
	Repeat for the other side.

left hand end bracket

top section

(3) 5/16” x 1-5/8”

LAG SCREWS

left hand end

bracket

top section

15	Center Bearing Bracket	Mounting surface
Tools Needed:	Measure to locate the center of the door	Equal distance
	and mark a vertical pencil line on the
Power Drill	mounting surface above the door, to	Center of	Center bearing
	indicate the center line of the door. Then,	end bearing	bracket
7/16” Socket	measure from the center of the bearing, in	bracket	Vertical line
Driver	one of the end bearing brackets, DOWN to
	the top of the door. Using that dimension,
		Horizontal line
	measure UP from the top of the door
Level
	and mark a horizontal pencil line on the
Tape Measure	mounting surface, intersecting the vertical
	pencil line. Now align the edge of the center
Pencil	bearing bracket along the vertical pencil	(1) 5/16” x 1-5/8” lag screw	Center
	line on the mounting surface. Center the		bearing
	bearing bracket on the horizontal line. This	Mounting	bracket
1/4” Torx Bit	will ensure the torsion tube is level between
		surface
	the center and end bearing brackets. Attach
	the center bearing bracket, in this location,	Horizontal line
	to the mounting surface, using (2) 5/16”
	x 1-5/8” lag screws and (1) 5/16” x 2”
	tamper-resistant lag screw.
	IMPORTANT: Use the 5/16” x 2” tamper-
	resistant lag screw ONLY if mounting	(1) 5/16” x 1-5/8” lag screw
	surface mounted over masonry.
	Tamper-resistant lag screw MUST be	(1) 5/16” x 2”
	attached through the bottom hole
		Tamper-resistant lag
	of the center bearing bracket.		Vertical
		screw
			line
22	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com