Wayne-Dalton 341785 Top Brackets, Do Not Raise Door Until, Horizontal Tracks Are, Injury

13	Top Brackets
Tools Needed:	Remove, but retain (2-4) 1/4”- 14 x 7/8”
Power Drill	self drilling screws from the right side of
	the u-bar, allowing enough room to slide
7/16” Socket	the top bracket between the section
	and the u-bar.
Driver
Hammer	Insert a roller into the low headroom
	top bracket. Slide the low headroom top
	bracket assembly between the u-bar
	and section, as shown.
	Twist the roller into the upper track.
	Align the edge of the top bracket
	assembly parallel to the section edge.
	Secure the top bracket and u-bar to
	the section with (3) 1/4”- 20 x 7/8” self
	drilling screws through the upper and
	lower slots of the bracket, as shown.
	Finish re-attaching the u-bar using the
	1/4”- 20 x 7/8” self drilling screws
	removed previously. Repeat for left hand
	side.
	Remove the nail that was temporarily
	holding the top section in place.
	IMPORTANT: Failure to remove nail
	before attempting to raise door
	could cause permanent damage to
	top section.
	WARNING
	DO NOT RAISE DOOR UNTIL
	HORIZONTAL TRACKS ARE
	SECURED AT REAR, AS OUTLINED
	IN STEP 21, OR DOOR COULD
	FALL FROM OVERHEAD POSITION
	CAUSING SEVERE OR FATAL
	INJURY.

top bracket

assembly

	(3) 1/4”-20 x 7/8” self
top section
	drilling screws

top bracket

assembly

top section section edge

header

top bracket

assembly

INSTALLATION

top section
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.	21

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com