| Side Lock | |
|
| |
Tools Needed: | Install the side lock on the second | |
Power Drill | section of the door. Secure the lock to | |
the section with (4) 1/4”- 20 x 11/16” | ||
| ||
7/16” Socket | self drilling screws. Square the lock | |
assembly with the door section and | ||
Driver | align with the square hole in the vertical | |
Tape Measure | track. The side lock should be spaced | |
in approximately 1/8” from the section | ||
| edge. | |
| IMPORTANT: side locks must be | |
| removed or made inoperative in | |
| the unlocked position, if an | |
| operator is installed on the | |
| door. | |
| NOTE: After completing this step, | |
| continue with step 9 on page 17. | |
|
|
(4) 1/4”- 20 x 11/16” |
|
self drilling screws | 1/8” |
|
|
| Pull Rope | |
|
|
|
|
Tools Needed: |
| WARNING | |
|
|
| |
Power Drill |
|
|
|
| DO NOT INSTALL PULL ROPES | ||
1/8” Drill Bit |
| ON DOORS WITH ELECTRIC | |
| OPERATORS. CHILDREN MAY | ||
|
| BECOME ENTANGLED IN THE | |
|
| ROPE CAUSING SEVERE OR | |
|
| FATAL INJURY. | |
|
| Measure and mark the jamb | |
|
| approximately 48” to 50” (1220 to 1270 |
mm)from floor on the right or left side of jamb. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.
NO. 6 SCEW EYE
PULL ROPE
BOTTOM BRACKET
PULL ROPE
optional INSTALLATION
Please Do Not Return This Product To The Store. Contact your local | 29 |
To find your