Important Notice | Wayne-Dalton 3982 instruction

Image 1

Wayne-Dalton installation instructions Important Notice, Model 3982 idrive Extension Spring Kit

Contents

Model 3982 idrive Extension Spring Kit Important Notice System Requirements Table of ContentsFCC and IC Statement FCC Regulatory Information INSTALLATION AND USE INSTALLATION AND USE Hardware Kit: 3982 idrive Extension Spring Kit idrive Hardware Kit idrive Package Contents Tools Needed Available Accessories: For idrive Extension idrive Installation idrive Retro-ﬁtInstallationStep 1: Extension Spring Relief Step 2: Remove Front Sheave Step 4A: Track Width Conformation Step 4: Flag Bracket InstallationNOTE: In some instances there shown in step Step 6 Bottom Bracket Lifting Cables Step 5: Cable Drum InstallationNOTE Do not remove shrink wrap from cable drums until instructed to do so Step 8 Extension Spring Counterbalance Step 7: Drum Wrap Installationwrapped oppositely on the drum Step 10 Lower the Door Step 9: Safety Cable InstallationWARNING TO AVOID SEVERE IN JURY DO NOT PLACE FINGERS OR HAND NOTE Hold the opener by the main Step 11: idrive Opener/Torque Tube Assemblybody. Do not hold by the motor NOTE: Do not force the opener onto Step 13: Secure idrive Opener tion be pilot drilled using 1/8” drill bit Step 14: Disconnect InstallationNOTE: It is recommended that 1/4” lag screw loca and Owner’s Manual Step 15: Wall Station Installation Pre-OperationInstallation Jumper Settings: Opener Switch Settings Light FixtureStep 16 Multi-Opener/LightFixture Programming CEILING MOUNTING Step 17: Light Fixture Installation power back on at fuse box Light Fixture Installation ContinuedWALL MOUNTING NOTE: If wires must be lengthened or spliced into Step 18: Photoelectric Safety Sensor Installationnectors Installation Continued Photoelectric Safety Sensor CONVENIENT POWER OUTLET Step 19: Power Connection Standard WiringLIGHT FIXTURE POWER OUTLET RECEPTACLE #6 X 7/8 WOOD SCREWS POWER CORD FEMALE END OPENER Step 20 Power Connection Permanent Wiring Option Step 21 Securing the Opener Step 22: Photoelectric Safety Sensor Alignment Wall Station Programming Changing the wall station’s security code MOTOR OPERATED POSITION Step 24 Install RoutineUP/DOWN BUTTON PROFILE BUTTON Step 26: Lock Arm Installation Step 25: Detent Adjustment if requiredStep 27: Custom Settings Step 29: Contact Obstruction Test Step 28 Photoelectric Obstruction Sensor Test Change and Programming Step 30: Transmitter Security CodeCHANGING THE TRANSMITTER’S SECURITY CODE TRANSMITTER PROGRAMMING Step 31: Programming HomeLink to idrive Teaching Power Unitper Step PROGRAMMING Training HomeLink Unit 8.SAVE THESE INSTRUCTIONS Important Safety InstructionsOperation Transmitter Operation Wall Station Operation service person immediately MOTOR DOWN POSITION DOOR LOCKED Manual Door Operation Emergency DisconnectDISCONNECTED, MOTOR UP POSITION Monthly Maintenance MaintenanceBattery replacement NOTE: Dispose of dead batteries properly SYMPTOM TroubleshootingPROBABLE CAUSE CORRECTIVE ACTION Lock Arm Troubleshooting Troubleshooting continuedSYMPTOM SYMPTOM LIFETIME LIMITED WARRANTY Wayne-DaltonCustomer ServiceQuestions?? For quick answers and helpful advise, call

Wayne-Dalton 3982 installation instructions Important Notice

Models: 3982