Photoelectric Obstruction Sensor Test | Wayne-Dalton 3982 specification

Image 27

Wayne-Dalton 3982 installation instructions Photoelectric Obstruction Sensor Test, Contact Obstruction Test

Contents

Model 3982 idrive Extension Spring Kit Important Notice FCC Regulatory Information Table of ContentsSystem Requirements FCC and IC Statement INSTALLATION AND USE INSTALLATION AND USE Hardware Kit: 3982 idrive Extension Spring Kit idrive Hardware Kit idrive Package Contents Tools Needed Available Accessories: For idrive Step 2: Remove Front Sheave idrive Retro-ﬁtInstallationExtension idrive Installation Step 1: Extension Spring Relief shown in step Step 4: Flag Bracket InstallationStep 4A: Track Width Conformation NOTE: In some instances there drums until instructed to do so Step 5: Cable Drum InstallationStep 6 Bottom Bracket Lifting Cables NOTE Do not remove shrink wrap from cable Step 7: Drum Wrap Installation Step 8 Extension Spring Counterbalancewrapped oppositely on the drum JURY DO NOT PLACE FINGERS OR HAND Step 9: Safety Cable InstallationStep 10 Lower the Door WARNING TO AVOID SEVERE IN NOTE: Do not force the opener onto Step 11: idrive Opener/Torque Tube AssemblyNOTE Hold the opener by the main body. Do not hold by the motor Step 13: Secure idrive Opener and Owner’s Manual Step 14: Disconnect Installationtion be pilot drilled using 1/8” drill bit NOTE: It is recommended that 1/4” lag screw loca Step 15: Wall Station Installation Pre-OperationInstallation Switch Settings Light Fixture Jumper Settings: OpenerStep 16 Multi-Opener/LightFixture Programming CEILING MOUNTING Step 17: Light Fixture Installation Light Fixture Installation Continued power back on at fuse boxWALL MOUNTING Step 18: Photoelectric Safety Sensor Installation NOTE: If wires must be lengthened or spliced intonectors Installation Continued Photoelectric Safety Sensor #6 X 7/8 WOOD SCREWS POWER CORD FEMALE END OPENER Step 19: Power Connection Standard WiringCONVENIENT POWER OUTLET LIGHT FIXTURE POWER OUTLET RECEPTACLE Step 20 Power Connection Permanent Wiring Option Step 21 Securing the Opener Step 22: Photoelectric Safety Sensor Alignment Wall Station Programming Changing the wall station’s security code Step 24 Install Routine MOTOR OPERATED POSITIONUP/DOWN BUTTON PROFILE BUTTON Step 25: Detent Adjustment if required Step 26: Lock Arm InstallationStep 27: Custom Settings Step 29: Contact Obstruction Test Step 28 Photoelectric Obstruction Sensor Test TRANSMITTER PROGRAMMING Step 30: Transmitter Security CodeChange and Programming CHANGING THE TRANSMITTER’S SECURITY CODE PROGRAMMING Training HomeLink Unit Teaching Power UnitStep 31: Programming HomeLink to idrive per Step Transmitter Operation Important Safety Instructions8.SAVE THESE INSTRUCTIONS Operation Wall Station Operation service person immediately Manual Door Operation Emergency Disconnect MOTOR DOWN POSITION DOOR LOCKEDDISCONNECTED, MOTOR UP POSITION NOTE: Dispose of dead batteries properly MaintenanceMonthly Maintenance Battery replacement CORRECTIVE ACTION TroubleshootingSYMPTOM PROBABLE CAUSE SYMPTOM Troubleshooting continuedLock Arm Troubleshooting SYMPTOM For quick answers and helpful advise, call Wayne-DaltonCustomer ServiceLIFETIME LIMITED WARRANTY Questions??

Wayne-Dalton 3982 Photoelectric Obstruction Sensor Test, Contact Obstruction Test

Models: 3982