Securing the Opener | Wayne-Dalton 3982 specs

Image 23

Wayne-Dalton 3982 installation instructions Securing the Opener, Photoelectric Safety Sensor Alignment

Contents

Model 3982 idrive Extension Spring Kit Important Notice FCC Regulatory Information Table of ContentsSystem Requirements FCC and IC Statement INSTALLATION AND USE INSTALLATION AND USE Hardware Kit: 3982 idrive Extension Spring Kit idrive Hardware Kit idrive Package Contents Tools Needed Available Accessories: For idrive Step 2: Remove Front Sheave idrive Retro-ﬁtInstallationExtension idrive Installation Step 1: Extension Spring Relief shown in step Step 4: Flag Bracket InstallationStep 4A: Track Width Conformation NOTE: In some instances there drums until instructed to do so Step 5: Cable Drum InstallationStep 6 Bottom Bracket Lifting Cables NOTE Do not remove shrink wrap from cable wrapped oppositely on the drum Step 7: Drum Wrap InstallationStep 8 Extension Spring Counterbalance JURY DO NOT PLACE FINGERS OR HAND Step 9: Safety Cable InstallationStep 10 Lower the Door WARNING TO AVOID SEVERE IN NOTE: Do not force the opener onto Step 11: idrive Opener/Torque Tube AssemblyNOTE Hold the opener by the main body. Do not hold by the motor Step 13: Secure idrive Opener and Owner’s Manual Step 14: Disconnect Installationtion be pilot drilled using 1/8” drill bit NOTE: It is recommended that 1/4” lag screw loca Step 15: Wall Station Installation Pre-OperationInstallation Step 16 Multi-Opener/LightFixture Programming Switch Settings Light FixtureJumper Settings: Opener CEILING MOUNTING Step 17: Light Fixture Installation WALL MOUNTING Light Fixture Installation Continuedpower back on at fuse box nectors Step 18: Photoelectric Safety Sensor InstallationNOTE: If wires must be lengthened or spliced into Installation Continued Photoelectric Safety Sensor #6 X 7/8 WOOD SCREWS POWER CORD FEMALE END OPENER Step 19: Power Connection Standard WiringCONVENIENT POWER OUTLET LIGHT FIXTURE POWER OUTLET RECEPTACLE Step 20 Power Connection Permanent Wiring Option Step 21 Securing the Opener Step 22: Photoelectric Safety Sensor Alignment Wall Station Programming Changing the wall station’s security code UP/DOWN BUTTON PROFILE BUTTON Step 24 Install RoutineMOTOR OPERATED POSITION Step 27: Custom Settings Step 25: Detent Adjustment if requiredStep 26: Lock Arm Installation Step 29: Contact Obstruction Test Step 28 Photoelectric Obstruction Sensor Test TRANSMITTER PROGRAMMING Step 30: Transmitter Security CodeChange and Programming CHANGING THE TRANSMITTER’S SECURITY CODE PROGRAMMING Training HomeLink Unit Teaching Power UnitStep 31: Programming HomeLink to idrive per Step Transmitter Operation Important Safety Instructions8.SAVE THESE INSTRUCTIONS Operation Wall Station Operation service person immediately DISCONNECTED, MOTOR UP POSITION Manual Door Operation Emergency DisconnectMOTOR DOWN POSITION DOOR LOCKED NOTE: Dispose of dead batteries properly MaintenanceMonthly Maintenance Battery replacement CORRECTIVE ACTION TroubleshootingSYMPTOM PROBABLE CAUSE SYMPTOM Troubleshooting continuedLock Arm Troubleshooting SYMPTOM For quick answers and helpful advise, call Wayne-DaltonCustomer ServiceLIFETIME LIMITED WARRANTY Questions??

Wayne-Dalton 3982 Securing the Opener, Photoelectric Safety Sensor Alignment

Models: 3982