Hardware Kit: 3982 idrive Extension Spring Kit | Wayne-Dalton

Image 4

Wayne-Dalton installation instructions Hardware Kit: 3982 idrive Extension Spring Kit

Contents

Important Notice Model 3982 idrive Extension Spring Kit Table of Contents System RequirementsFCC and IC Statement FCC Regulatory Information INSTALLATION AND USE INSTALLATION AND USE Hardware Kit: 3982 idrive Extension Spring Kit idrive Package Contents idrive Hardware Kit Available Accessories: For idrive Tools Needed idrive Retro-ﬁtInstallation Extension idrive InstallationStep 1: Extension Spring Relief Step 2: Remove Front Sheave Step 4: Flag Bracket Installation Step 4A: Track Width ConformationNOTE: In some instances there shown in step Step 5: Cable Drum Installation Step 6 Bottom Bracket Lifting CablesNOTE Do not remove shrink wrap from cable drums until instructed to do so Step 8 Extension Spring Counterbalance Step 7: Drum Wrap Installationwrapped oppositely on the drum Step 9: Safety Cable Installation Step 10 Lower the DoorWARNING TO AVOID SEVERE IN JURY DO NOT PLACE FINGERS OR HAND Step 11: idrive Opener/Torque Tube Assembly NOTE Hold the opener by the mainbody. Do not hold by the motor NOTE: Do not force the opener onto Step 13: Secure idrive Opener Step 14: Disconnect Installation tion be pilot drilled using 1/8” drill bitNOTE: It is recommended that 1/4” lag screw loca and Owner’s Manual Pre-OperationInstallation Step 15: Wall Station Installation Jumper Settings: Opener Switch Settings Light FixtureStep 16 Multi-Opener/LightFixture Programming Step 17: Light Fixture Installation CEILING MOUNTING power back on at fuse box Light Fixture Installation ContinuedWALL MOUNTING NOTE: If wires must be lengthened or spliced into Step 18: Photoelectric Safety Sensor Installationnectors Photoelectric Safety Sensor Installation Continued Step 19: Power Connection Standard Wiring CONVENIENT POWER OUTLETLIGHT FIXTURE POWER OUTLET RECEPTACLE #6 X 7/8 WOOD SCREWS POWER CORD FEMALE END OPENER Step 20 Power Connection Permanent Wiring Option Step 22: Photoelectric Safety Sensor Alignment Step 21 Securing the Opener Changing the wall station’s security code Wall Station Programming MOTOR OPERATED POSITION Step 24 Install RoutineUP/DOWN BUTTON PROFILE BUTTON Step 26: Lock Arm Installation Step 25: Detent Adjustment if requiredStep 27: Custom Settings Step 28 Photoelectric Obstruction Sensor Test Step 29: Contact Obstruction Test Step 30: Transmitter Security Code Change and ProgrammingCHANGING THE TRANSMITTER’S SECURITY CODE TRANSMITTER PROGRAMMING Teaching Power Unit Step 31: Programming HomeLink to idriveper Step PROGRAMMING Training HomeLink Unit Important Safety Instructions 8.SAVE THESE INSTRUCTIONSOperation Transmitter Operation service person immediately Wall Station Operation MOTOR DOWN POSITION DOOR LOCKED Manual Door Operation Emergency DisconnectDISCONNECTED, MOTOR UP POSITION Maintenance Monthly MaintenanceBattery replacement NOTE: Dispose of dead batteries properly Troubleshooting SYMPTOMPROBABLE CAUSE CORRECTIVE ACTION Troubleshooting continued Lock Arm TroubleshootingSYMPTOM SYMPTOM Wayne-DaltonCustomer Service LIFETIME LIMITED WARRANTYQuestions?? For quick answers and helpful advise, call