Wayne-Dalton 9800 installation instructions Vertical Track, Stacking Sections, Installation

7	Vertical Track
Tools Needed:	IMPORTANT: The tops of the
3/16” Drill Bit	vertical tracks must be level
	from side to side. If the bottom
Power Drill	section was shimmed to level it.
7/16” Socket	The vertical track on the shimmed
	side, must be raised the height of
Driver	the shim.
Tape Measure	Position the left hand vertical track
Level	assembly over the rollers of the bottom
	section. Make sure the counterbalance
	cable is located between the rollers and
	the door jamb. Drill 3/16” pilot holes for
	the lag screws. Loosely fasten jamb
	brackets and flagangles to the jamb

CABLE	fLAGANGLE
DRUM
	5/16” x 1-5/8”
	LAG SCREWS
	VERTICAL
	TRACK
	ASSEMBLY

veritcal track

BOTTOM SECTION

5/8”

roller

LAG

SCREW

locations

Quick install and fully adjustable

flagangle lag locations

using 5/16” x 1-5/8” lag screws.

Tighten lag screw securing bottom

jamb bracket to jamb, to maintain

5/8” spacing. Hang cable drum over

flagangle. Repeat for the right side.

JAMB

BRACKET

BOTTOM SECTION

quick install jamb bracket

lag

screw

INSTALLATION

8	Stacking Sections
Tools Needed:	NOTE: For door section identification	LOCK SECTION
	see page 4.
Power Drill
	NOTE: Make sure hinge leafs are flipped
7/16” Socket	down, when stacking another section
Driver	on top.

Place rollers in hinge tubes of the second section (lock section). With assistance, lift second section and guide rollers into the vertical tracks.

Align vertical marks in the upper
alignment sticker, with the lower
alignment sticker on right hand side
on the back of door. Keep sections
aligned and fasten hinges to connect
the sections using 1/4” - 14 x 5/8”	(2) 1/4” - 14 X 5/8”	(2) 1/4” - 14 X 5/8”
self-tapping screws. Repeat for other
section(s) except top section.	SELF-TAPPING SCREWS	SELF-TAPPING SCREWS
IMPORTANT: When securing the end
hinges to the sections with 1/4”
- 14 x 5/8” self-tapping screws,		Alignment
ensure they are attached as		stickers
shown in the illustrations above.	Left end hinge	Right end hinge

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local15 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com