Wayne-Dalton 9800 installation instructions Operator Bracket, Stacking Sections

8	Stacking Sections
Tools Needed:	IMPORTANT: Push & hold the hinge
Power Drill	leafs against section while
	securing with 1/4” - 14 x 5/8”
7/16” Socket
	self-tapping screws. End Hinges
Driver	have (2) screws and Intermediate
	hinges have (3) screws.
	NOTE: Install lock at this time (sold
	separately) see instructions in
	OPTIONAL SIDELOCK INSTALLATION on
	page 33.

(3)1/4” - 14 X 5/8” SELF-TAPPING SCREWS

Intermediate hinge

(2) 1/4” - 14 X 5/8”

SELF-TAPPING SCREWS

End hinges (left hand shown, right hinge symmetrically opposite)

(3) 1/4” - 14 X 5/8”

SELF-TAPPING

SCREWS

Intermediate hinges

9	Operator Bracket
Tools Needed:	NOTE: If installing a trolley type operator,	Side view of u-bar		U-bar
	complete this step. If not, skip this step and
Power Drill	continue with step 10.	u-bar
	IMPORTANT: When installing a trolley
	type operator on 9800 door, a Wayne-		Operator
7/16” Socket	Dalton trolley bracket must be		bracket
	securely attached to the top section.
Driver
	It is then unnecessary to further	1/4”-20 X 7/8”
	reinforce the top section of the
		self drilling
	model 9800 Wayne-Dalton door, when
		screws
	attaching a trolley type operator,
				Top edge of
	as long as the installation of the
	operator is according to Installation			operator
	instructions and owner’s manual			bracket
	and force settings are adjusted
	properly.		Top of
	Remove, but retain (4-6) 1/4”- 20 x 7/8”	U-bar	section	U-bar
	self drilling screws from the center of the
	u-bar, allowing the operator bracket to slide
	between the section and the u-bar.
	NOTE: For retro fit applications, the operator
	bracket must be aligned with an existing			Operator
	operator
				bracket
	Locate the center of the top section and	Operator
			Side view of u-bar with
	slide operator bracket under u-bar till the	bracket
	operator bracket is seated against the u-bar		Operator bracket installed
	flange. NOTE: Prior to fastening operator
	bracket to top section, ensure the top edge
	of operator bracket is aligned with the top
	edge of the section as shown on far right.
	Attach the operator bracket using (6) 1/4”-
	20 x 5/8” self drilling screws (as shown).	Operator bracket in		(6) 1/4”-20 X 5/8”
	Finish re-attaching the u-bar using the self			self drilling
	tapping screws removed previously.	place under u-bar		screws

16 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com