12 | Attaching Horizontal Track to |
|
|
| Adjustable Flagangle |
|
|
Tools Needed: | NOTE: If quick install flagangle was |
|
|
7/16” Socket | installed in Step 11, skip this step and |
|
|
continue with Step 13. If not, complete |
|
| |
|
|
| |
Ratchet Wrench | this step. | Flagangle | Stud |
|
| ||
7/16” Wrench | To install horizontal track, place the |
| plate |
|
| ||
Level | curved end over the top roller. Align |
|
|
the bottom of the horizontal track with |
|
| |
Flat Tip | the vertical track. Hand tighten the |
|
|
horizontal track to the flagangle with | 1/4” - 20 |
| |
Screwdriver |
| ||
(1) stud plate and (2) 1/4” - 20 flange | flange hex |
| |
|
| ||
| hex nuts. | nuts |
|
| Level horizontal track and bolt the top |
|
|
| curve of the low headroom horizontal |
| INSTALLATION |
| track slot in the flagangle using (1) |
| |
|
|
| |
| 5/16” washer, (1) 1/4”- 20 track bolt |
|
|
| and (1) 1/4”- 20 flange hex nut. Repeat |
|
|
| for other side. |
|
|
| NOTE: If an idrive® opener will be |
|
|
| installed, position horizontal tracks |
|
|
| slightly above level. |
|
|
|
| flagangle | (1) 1/4”- 20 x 9/16” |
|
| track bolt | |
|
|
| |
|
| (1) 5/16” washer |
|
|
| (1) 1/4”- 20 |
|
|
| flange |
|
|
| hex nut |
|
|
|
| top curve of |
|
|
| low headroom |
|
|
| horizontal track |
Please Do Not Return This Product To The Store. Contact your local | |||
| yellow pages business listings or go to the Find a Dealer section online at |