Wayne-Dalton 9800 Mounting Disconnect, Handle Bracket, Attaching Disconnect Cables, Installation

23	Attaching Disconnect Cables
Tools Needed:	NOTE: See idrive® main installation and
Pliers	owners manual for idrive® parts.

Attach the loose disconnect cable (located in opener hardware bag) to the opener with the “S” hook. Close both ends of the “S” hook with pliers, to lock assembly together.

Thread the disconnect cable (behind the counterbalance cable) through the hole in the right hand end bracket. Remove all slack between opener and right end bracket.

S-Hook

Disconnect

Cable

Hole in Right

End Bracket

Right Side of

End Bracket

Hole in Close “S” Hook

End Bracket

INSTALLATION

24	Mounting Disconnect
	Handle Bracket
Tools Needed:	NOTE: See idrive® main installation and
Pencil	owners manual for idrive® parts.
Tape Measure	Mark a location on the right jamb, 6
	feet above the floor to mount the
1/8” Drill Bit	disconnect handle bracket.
7/16” Socket	Drill 1/8” pilot holes for the lag screws.
Driver
Power Drill	Align top of the bracket with the mark.
	Fasten bracket to the jamb with
	(2) 1/4” x 1-1/2" lag screws.

6 ft.

(2) 1/4” x 1-1/2” Lag Screws

Disconnect

Handle Bracket

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local27 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com