Wayne-Dalton 9800 installation instructions Door Section Identification

	Door Section Identification
Tools Needed:	NOTE: This provides an alternative method
	for identifying your door sections/stacking
	position.
	Hinges are always pre-attached at the top	#3	Top Section
	of each section (except top section) and
	the hinges are stamped for identification,		warning label
	#1, #2, #3, and #4 (#4 only on five
	section doors). See view below. The		(maybe on right
			or left haNd side)
	stamp identifies the stacking sequence
	of the section. The sequence is always
	determined by #1 being the bottom		Intermediate Section
	section to #3 or #4 being the highest	#2
	intermediate section. See views to the
	right. If the stamp on the end hinge is
	illegible, refer to the section side view
	illustration to the right.
	The section side view illustration shows
	the end hinge profile of all the sections,		Lock Section
	and can also be used in conjunction with	#1
	identifying each sections.
	The bottom section can be identified		Bottom Bracket
	by #1 end hinges, the factory attached		warning Labels
	bottom astragal and by the bottom
	bracket warning labels on each end stile.
	The lock section can be identified by a		Bottom Section
	#2 end hinge.	astragal
	The intermediate section can be		SECTION side view
	identified by #3 end hinges. The section
	will have a warning label attached to		1 3/8”	1 1/8”	7/8”
	either the right or left hand end stile.
	NOTE: #4 End hinges are used on the
	fourth section of five section doors.
	The top section can be identified by the	u-bar
	pre-attached u-bar and no pre-installed		#3 end	#2 end	#1 end
	end or center hinges on the section.		hinge	hinge	hinge

Top INT. LOCK BOT.

BOTTOM

BRACKET

typical hinge stamping location

ASTRAGAL

4Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com