![Counter Installation](/images/new-backgrounds/46527/4652749x1.webp)
|
| |
20 | Counter Installation | |
| ||
|
| |
Tools Needed: | Install the right side counter gear, with | |
None | the missing tooth toward the outside | |
and away from the end bracket. Press | ||
| ||
| the counter gear onto the end bracket | |
| until snaps engage. | |
| Select the right hand counter cover and | |
| align the hex of the counter cam with | |
| the end of the winding shaft. Also, align | |
| the “0” on the counter cover with the | |
| raised rib on the end bracket. Press the | |
| counter cover against the counter gear | |
| until it locks into place. | |
| Repeat for left hand side for double | |
| spring applications. | |
| NOTE: No drive gear, counter gear or | |
| counter cover is required on left hand | |
| side for single spring applications. Only | |
| an end bracket is needed. | |
| IMPORTANT: At this time do not | |
| wind Counterbalance Springs! | |
|
|
Winding
Shaft Inside
End Bracket
Counter
Gear Missing
Tooth
Counter
Cover
Raised Rib
“0”
Hex of the
Counter Cam
INSTALLATION
|
|
| |
21 | Securing Center Bracket Bushing | CENTER | |
| NOTE: If you are installing the idrive® | ||
Tools Needed: | BRACKET | ||
opener on your garage door, skip this step | |||
| ASSEMBLY | ||
1/8” Drill Bit | and continue with Step 22. |
| |
|
| ||
7/16” Socket | NOTE: If you are installing a Doormaster™ |
| |
opener, see optional Doormaster™ Bracket |
| ||
Driver | installations on page 34, Figure B. |
| |
Power Drill | NOTE: If you are not installing the |
| |
| idrive® opener on your garage door, you |
| |
| must install the center bracket bushing |
| |
| assembly. Follow these instructions for |
| |
|
|
IMPORTANT: TorqueMaster® spring tube must be level after center bracket assembly is mounted to header.
To locate the center bracket, mark the |
|
header halfway between the flagangles |
|
and level the TorqueMaster® spring tube. |
|
Drill 1/8” pilot holes into header for the lag |
|
screws. Fasten the metal bracket to the | (2) 5/16” x |
header using (2) 5/16” x | |
screws. | hex head lag |
| screws |
NOTE: Upon completion of this step, continue with step 26.
Please Do Not Return This Product To The Store. Contact your local