Wayne-Dalton 9800 installation instructions idrive Installation

16	idrive® Installation
Tools Needed:	NOTE: See idrive® main installation and
None	owners manual for idrive® parts.
	IMPORTANT: Right and left hand
	is always determined from inside	Left Hand Side
	the garage looking out.
		TorqueMaster® Spring Tube
		and Bearing profiles aligned	Motor
	Lay the TorqueMaster® spring tube on
	the floor (inside garage) in front of the
	door with the labeled end to the left.
	Look into the opener’s left side to	Right Hand End
	ensure the left hand bearing and the
	internal (black) sleeve are aligned with	of TorqueMaster®
		Spring Tube
	the TorqueMaster® spring tube profile.
	IMPORTANT: Hold Opener by the
	main body. Do NOT hold by the
	Motor.
	NOTE: Opener will not slide over the
	TorqueMaster® spring tube label.
	Attempting to slide opener over the left
	end of the TorqueMaster® spring tube
	can damage the internal electronics.
	Once aligned, slide the opener onto the
	right hand end of the TorqueMaster®
	spring tube. As the right end of the
	TorqueMaster® spring tube enters the
	internal (black) sleeve, rotate the		Right Hand Side
	opener back and forth slightly to help		TorqueMaster®
	aid alignment.		Spring Tube and
			Bearing profiles
	Continue sliding the opener onto the		aligned
	TorqueMaster® spring tube. Align the
	right hand bearing with the
	TorqueMaster® spring tube and slide
	the opener completely onto the
	TorqueMaster® spring tube until the
	TorqueMaster® spring tube exits the
	opener’s right hand bearing.
	NOTE: If misalignment occcurs do not
	force opener onto TorqueMaster® spring
	tube.
	Continue sliding the opener to the
	center of the TorqueMaster® spring
	tube.		Plug-in Motor
			Power Cord
	Plug the motor power cord into the
	opener.

22 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com