|
|
| |
14 | TorqueMaster® Spring Tube | ||
| |||
|
|
| |
Tools Needed: | TorqueMaster® springs come lubricated | ||
None | and | ||
Torquemaster® spring tube. To install, lay | |||
| |||
| the Torquemaster® spring tube on the | ||
| floor (inside garage) in front of the door | ||
| with the labeled end to the left. | ||
| Important: RIGHT AND LEFT HAND IS | ||
| ALWAYS DETERMINED FROM INSIDE THE | ||
| garage LOOKING OUT. |
TorqueMaster®
Spring Tube
LABELED END
15 | Center Bracket Bushing | CENTER |
| BRACKET | |
| ASSEMBLY | |
Tools Needed: | NOTE: If you are installing the idrive® |
|
None | opener on your garage door, skip this |
|
step and continue with Step 16. |
| |
|
| |
| NOTE: If you are not installing the |
|
| idrive® opener on your garage door, you | ® |
| must install the center bracket bushing | TorqueMaster |
| Spring Tube | |
| assembly. Follow these instructions for |
|
|
| |
| NOTE: If you are installing a |
|
| Doormaster™ opener, see optional | TorqueMaster® |
| Doormaster™ Bracket installations on | |
| page 34, Figure A. | Spring Tube |
|
| |
| Being cam shaped, the center bracket |
|
| bushing only fits one way. |
|
| Slide the center bracket assembly |
|
| towards the center of the TorqueMaster® |
|
| spring tube, from the right side as shown. | CENTER |
|
| |
| NOTE: Upon completion of this step, | BRACKET |
| BUSHING | |
| continue with Step 17. |
|
Please Do Not Return This Product To The Store. Contact your local
INSTALLATION