Wayne Shallow Well Electrical, Installation, (A), POZO(C), POZO(E), EXCAVADO, ! WARNING, ! CAUTION, ! WARNING, ! WARNING, MANANTIAL, PERFORADO, (Continued), CISTERNA(F)

Operating Instructions and Parts ManualShallow Well Jet Pump

Manual de instrucciones de operación y piezas Modelos para pozos profundos

Installation			Prime		4. If necessary, precharge with an air
(Continued)			Plug		pump to 28 - 30 psi on 1/2, 3/4 and 1
					HP pumps.
		Pressure
NOTE: A packer type foot valve can be				Air	5. Slope the horizontal pipes upward
		Switch
installed in the well (Figure 3,				Volume	toward the pump to prevent
Illustration B). This type of foot valve				Control	trapping air. If the horizontal
				Tubing
allows the well to be filled with water					distance exceeds 25 feet, see Chart
when priming and makes the inlet pipe					2 for the recommended pipe size.
much easier to test for leaks. Follow
the manufacturer’s instructions when				Air	Electrical
installing the packer type foot valve.
As an alternative, an in-line check valve				Volume	! WARNING	Risk of electrical
		Figure 4 - Horizontal Tank		Control		shock. This pump is
can be used with a driven well (Figure					designed for indoor installation only.
3, Illustration C). The pipe between the					The voltage of power supply must
check valve and the water level will			Air
					match the voltage of the pump. All
always be under a vacuum.			Volume
					above ground well pumps except
Leaking joints or couplings will allow			Control
			Air Volume		SWS50BOOST have dual voltage motors
air to leak into the pipe and cause			Control		preset at the factory to 230 volts. The
abnormal pump operation. Make sure			Tubing		motors can be converted to 115 volts
to use pipe joint compound on all male		Outlet			by turning the voltage selector to the
pipe threads.					desired voltage (See Figure 7). Use a
DUG WELL, CISTERN, LAKE AND SPRING					needle nose pliers to pull the selector
INSTALLATION (FIGURE 12)					out approximately 1/4”, rotate and
1. Install a foot valve on inlet pipe and					then reinsert in correct position.
			Hose
lower into water.
			Coupling
! CAUTION	The foot valve	Figure 5 - Vertical Tank
	should be at least
18” from the bottom of the well or		noise transmitted to the house
sand or sediment could be drawn into		thrugh the piping.			230 V
the system.		4. Provide a hose bib (faucet) at the
NOTE: When a lake is used as a water					115 V
		lowest point in the system to drain
supply, make sure the inlet pipe is deep
		the system for service or storage.
enough to be submerged at all times.
Slope the horizontal piping upward		SHALLOW WELL PUMP WITH
toward the pump to prevent trapping
		PRECHARGED STORAGE TANK
air. The pipe must be removed during
		(FIGURE 6)				230 V
winter months or protected against
freezing.		Motor	Outlet	Priming
				Plug
Protect the pipe from damage from					115 V
swimmers and boats.				Nozzle	Figure 7 - Voltage Selector
	Install a screen
! WARNING				Clean	Select the proper size wire and fuse
	around the inlet			Out
pipe to prevent the entrapment of				Drain	(Chart 3). Time delay fuses are
swimmers.					recommended over standard fuses for
SHALLOW WELL PUMP WITH				Fitting	motor circuit protection. All pump
CONVENTIONAL STORAGE TANK			28-30 psi		motors have built-in automatic
(FIGURES 4 & 5)					overload protection that will prevent
			3/4 HP & 1 HP
1. Install air volume control on tank.					damage to the motor due to
					overheating.
2. Connect the copper tube from the
		Figure 6 - Precharged Storage Tank				Do not connect to
air volume control to the					! WARNING
uppermost 1/8” NPT opening on the						electric power
		1. Shut off the power to the pump.			supply until unit is permanently
side of pump. Be sure the
					grounded. Connect ground wire to
connections are tight. Leaking can		2. Open the faucet nearest the tank			approved ground then connect terminal
cause the pump not to prime.		and allow all water to drain from			provided.
3. Install a valve and an isolator hose		the tank.			A metal underground water pipe or
between the tank and the house		3. Measure the tank precharge at the			well casing at least 10 feet long makes
plumbing to aid in pump removal		valve stem using a tire pressure			the best ground electrode. If plastic
for servicing and for reducing the		gauge.			pipe or insulated fittings are used, run

www.waynewatersystems.com

			.arcilla o roca	como tales impermeables	materiales entre	atrapada está permeables
				.irrigación o	tales fines para	Puede .humano
					lavado como	utilizada ser
		.derrumbe se que	evitar para concreto	o piedra ladrillo,	con reviste se Luego	.superficial basante
(2") cm 5,1 y	(1") cm 2,5 entre fluctúan	comunes diámetros Los	.pies) (50 m 15,25 a	menor es general lo por	profundidad La .freática	capa la de debajo
pozos para (6") cm 15,2 doméstico uso de agua de	y (4") cm 10,2 (3"), cm 7,6	(2"), cm 5,1 son comunes	diámetros Los .pies) (1000	m 305 de más hasta pies	algunos entre fluctúan	profundidades Las
.
				.humano	para apta	El .techos
					consumo	es no agua

Figura 13 - Suministros de Agua

materiales en agua el

cuando Ocurre .tierra la de

emerge que manantial Un

MANANTIAL: (A)

(A)

ESQUISTO

LAGO, (B) ARROYO, ESTANQUE

MANANTIAL

consumo para apta es no

general lo por tratada, sea que

menos a que superficial, Agua

ESTANQUE: o ARROYO LAGO, (B)

ACUIFERA

CAPA

TIERRA SUPERFICIAL

PERFORADO

POZO(C)

Aguade Suministros

.tuberíasconrevestidoportierra,la en punta profundidad unahasta

maquinariacontierralaconpantallauna con diámetro de piesvarios

enperforadohoyoUntuberíaunaacciona Se de hoyo un excavaSe

PERFORADO:POZO(E)ACCIONADO:POZO (D) EXCAVADO: POZO(C)

MATERIAL PERMEABLE

ARCILLA

POZO(E)

EXCAVADO

ARENA

POZO(D) ACCIONADO

losdelluviasdeagua

recolectarparaconstruido

subterráneotanqueUn

CISTERNA:(F)

FREATICA

CISTERNA(F)

y

29 Sp

4