June 23, 2010

T13/2132-D Revision 3

8.20.4.9.10 Bits 9-10 - translation type

If bit 3 is cleared to zero then this field shall be ignored and shall be zero. If bit 3 is set to one then this field identifies the geometric translation shown in table 26.

Table 26 — Translation Type

Bits 9-10

Description

00b Bit-shift translation

01b LBA assisted translation

10b Reserved

11b Vendor specific translation

8.20.4.9.11 Bit 11 - Ultra DMA

If the system is configured for Ultra DMA, this bit shall be set to one and byte 8 (DMA Channel/DMA Type) should be used to configure the system. If this bit and bit 1, (Bit 1 = fast DMA, clause 8.24.3.9.2) are cleared to zero, then the DMA Channel/DMA Type field shall be ignored.

8.20.4.9.12 Bit 12 - HPA Active

The HPA Active bit shall be set to one if the Host Protected Area (HPA) is active. The HPA is active if a volatile or non-volatile SETMAX has been issued with a value other than the NATIVE MAX address. This bit shall be cleared to zero if NATIVE MAX sectors can be accessed using read and/or write commands.

8.20.4.9.13 Bit 13h - 48-bit LBA addressing enabled

The 48-bit LBA addressing enabled bit shall be set to one if the INT 13h handler is using 48-bit extended commands to access the device. The 48-bit LBA addressing enabled bit shall be cleared to 0 if the INT 13h handler is not using 48-bit extended commands to access the device.

8.20.4.9.14Bits 14-15 - Reserved

8.20.4.10 Offset 12-13h - Reserved

8.20.4.11 Offset 14 - table revision

The table version shall be set to 30h indicating compliance with this standard.

8.20.4.12 Offset 15 - checksum

This shall be the two's complement of the 8-bit unsigned sum of bytes 0 through 14. Adding bytes 0 through 15 shall in all cases produce an 8-bit result of zero.

Working Draft Enhanced Disk Drive - 4 (EDD-4)

57

Page 69
Image 69
Western Digital manual June 23 T13/2132-D Revision Bits 9-10 translation type, Translation Type Bits Description