Western Telematic MPC-20VD20-1 manual DPL Set All Plugs to Default States, Format: /DPL,Y Enter

Command Reference Guide

/DPL Set All Plugs to Default States

Sets all switched outlets to their user-defined default state. For information on setting outlet defaults, please refer to Section 5.7.

Notes:

•When this command is invoked in Administrator Mode or SuperUser Mode, it will be applied to all MPC outlets. When invoked in User Mode, the command will only be applied to the plugs that are allowed by the account.

•If one or more optional AUX/Remote MPC units are connected to the AUX ports on your local unit, then the /DPL command will be applied to both the local MPC unit as well as any AUX/Remote MPC units.

Availability: Administrator, SuperUser, User

Format: /DPL[,Y] [Enter]

	Where ,Y is an optional command argument, which can be included to suppress the
	command confirmation prompt.
/C	Connect to Serial Port

When the RJ-45 AUX Ports and/or Remote Port have been configured as Serial Ports as described in Section 5.8.2, the /C command can be used to create a connection between the Network port and a serial mode AUX or Remote Port. In addition, the /C command can also be invoked to create a connection between the Network Port and the Console Port.

Notes:

•User level accounts can only connect to the ports that are specifically permitted by the account.

•The /C command cannot be used to create a connection between two serial ports.

•Administrator and SuperUser level accounts are allowed to connect to any MPC Serial Port.

•To terminate a serial port connection, either type ^X ([Ctrl] plus [X]) or invoke the currently defined disconnect sequence.

Availability: Administrator, SuperUser, User

Format: /C <x> [Enter]
Where x is the name of the serial port that you wish to connect to. The available
ports are "1" (the Console Port), "Remote", "AUX1", "AUX2" and "AUX3".
/U	Send Parameters to File

Sends all MPC configuration parameters to an ASCII text file as described in Section 13. This allows you to back up the configuration of your MPC unit.

Availability: Administrator

Format: /U [Enter]

17-8