Western Telematic MPC-20VD20-2 a Reboot Outlet, ii. Text Interface: Type /OFF A1 and press Enter

Getting Started

1.Access Command Mode: The MPC includes two user interfaces; the Text Interface and the Web Browser Interface. The Text Interface is available via Local PC, SNMP, SSH Client, Telnet, or Modem, and the Web Browser interface is only available via TCP/IP network. In addition, when contacted via PDA, the MPC will also present

a third interface, which is similar to the Web Browser Interface, but offers limited command functions.

a)Via Local PC: Start your communications program and then press [Enter].

b)Via SSH Client: Start your SSH client, enter the default IP address (192.168.168.168) for the MPC and invoke the connect command.

c)Via Web Browser: Make certain that Web Browser access is enabled as described in the Section 5.9 in this User's Guide. Start your JavaScript enabled Web Browser, enter the default MPC IP address (192.168.168.168) in the Web Browser address bar, and then press [Enter].

d)Via Telnet: Make certain that Telnet access is enabled as described in Section 5.9. Start your Telnet client, and enter the MPC’s default IP address (192.168.168.168).

e)Via Modem: Make certain that the MPC's serial Console Port has been configured for Modem Mode as described in Section 5.8, then use your communications program to dial the number for your external Modem connected to the Console Port.

2.Username / Password Prompt: A message will be displayed, which prompts you to enter your username (Login) and password. The default username is “super” (all lower case, no quotes), and the default password is also “super”. If a valid username and password are entered, the MPC will display either the Main Menu (Web Browser Interface) or the Port Status Screen (SSH, Telnet, or Modem.)

3.Test Switching Functions: You may wish to perform the following tests in order to make certain that the MPC is responding to commands. When switching and reboot commands are executed, the MPC's Status LEDs will also turn On or Off to indicate the status of each outlet.

a)Reboot Outlet:

i.Web Browser Interface: Click on the "Plug Control" link on the left hand side of the screen to display the Plug Control Menu. From the Plug Control Menu, click the down arrow in the row for Plug A1 to display the dropdown menu, then select "Reboot" from the drop down menu and click on the "Execute Plug Actions" button.

ii.Text Interface: Type /BOOT A1 and press [Enter].

b)Switch Outlet Off:

i.Web Browser Interface: From the Plug Control Menu, click the down arrow in the "Action" column for Plug A1 to display the drop down menu, then select "Off" from the drop down menu and click on the "Execute Plug Actions" button.

ii.Text Interface: Type /OFF A1 and press [Enter].

3-4