Western Telematic MPC-20VS20-2, MPC-20VD20-2, MPC-20VD20-1 Appendix F. Output Cable Keeper, Apx-13

Appendix F. Output Cable Keeper

The Output Cable Keeper extends approximately two inches above the face of the MPC-20V series unit, and provides a convenient means to tie output cables in place, to prevent cables from being accidentally disconnected.

To install the Output Cable Keeper on your MPC-20V series unit, please proceed as follows:

1.Refer to the electrical safety warnings in Section 4 and at the beginning of this user's guide, and then disconnect the input power supply cables from the MPC-20V unit. Next, remove the output cables from the MPC-20V, noting the precise plug/ location where each output cable was plugged in.

2.Align the Output Cable Keeper with the face of the MPC-20V unit as shown in Figure F.1 below. Note that there are two horizontally aligned screw holes at the top of the MPC-20V unit, and two vertically aligned screw holes at the bottom of the MPC-20V unit. Use the supplied mounting screws to securely attach the Cable Keeper to the face of the MPC-20V unit.

3.Reconnect the output cables to the same locations where they were previously plugged in, and then use a tie wrap to secure each output cable to the Cable Keeper.

Mounting

Screws

8.8.8	8.8.8
	PowerController
Managed

Outlet Cable Keeper

Screw

Holes

Mounting

Screws

Screw

Holes

Figure F.1: Installing the Output Cable Keeper (MPC-20V Series Units Only)

Apx-13