Western Telematic MPC-20VS20-2, MPC-20VD20-2, MPC-8H-1 Port Mode Parameters, AT&C1&D2S0=1&B1&H1&R2

Basic Configuration

Port Mode Parameters:

•Port Name: Allows you to assign a name to the Console Port. (Default = undefined.)

•Port Mode: The operation mode for this port. (Default = Normal Mode)

Depending on the Port Mode selected, the MPC will also display the additional prompts listed below. In the Text Interface, these parameters are accessible via a submenu, which will only be active when the appropriate port mode is selected. In the Web Browser Interface, fields will be "grayed out" unless the corresponding port mode is selected.

◆Normal Mode: Allows communication with a local PC and permits access to command mode. When the Normal Mode is selected, the following mode- specific parameter can also be defined:

➤DTR Output: Determines how DTR will react when the port disconnects. DTR can be held low, held high, or pulsed for 0.5 seconds and then held high. (Default = Pulse.)

◆Modem Mode: Permits access to command mode and simplifies connection to an external modem. Modem Mode ports can perform all functions normally available in Normal Mode, but Modem Mode also allows definition of the following, additional parameters:

➤Reset String: Redefines the modem reset string. The Reset String can be sent prior to the Initialization string. (Default = ATZ.)

➤Initialization String: Defines a command string that can be sent to

initialize a modem to settings required by your application. (Default =

AT&C1&D2S0=1&B1&H1&R2)

➤Hang-Up String: Although the MPC will pulse the DTR line to hang-up an attached modem, the Hang-Up string is often useful for controlling modems that do not use the DTR line. (Default = undefined.)

➤Periodic Reset Value: Determines how often the Reset String will be sent to the modem at this port.

Note: When communicating with the MPC via modem, these parameters will not be changed until after you exit command mode and disconnect.

5-43