Western Telematic MPC-20VD20-2, MPC-20VD20-1, MPC-20VS20-2, MPC-20VD16-3 SNMP Trap Parameters, 5-57

Basic Configuration

5.9.7.SNMP Trap Parameters

These menus are used to select parameters that will be used when SNMP traps are sent. For more information on SNMP Traps, please refer to Section 12. To define or change SNMP Trap parameters, proceed as follows:

•Text Interface: Type /N and press [Enter] to display the Network Parameters Menu (Figure 5.17.) At the Network Parameters Menu, type 26 and press [Enter] to display the SNMP Trap Parameters Menu.

•Web Browser Interface: Click on the "SNMP Traps" link on the left hand side of the MPC Home screen to display the SNMP Trap Parameters Menu.

Both the Text Interface and Web Browser Interface allow the following parameters to be defined:

•SNMP Manager 1: The IP Address for the first SNMP Manager. For more information, please refer to Section 12. (Default = Undefined.)

Note: In order to enable the SNMP Trap feature, you must define at least one SNMP Manager.

•SNMP Manager 2: (Default = Undefined.)

•Trap Community: (Default = Public.)

5-57