Troubleshooting Procedures
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or repair of this unit.
!
CAUTION
All safety information must be followed as provided in the Service Manual.
!WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing.
CONSOLE SWITCH TEST CON’T |
|
|
| Press the Cycle Selection Knob to activate | |
| the test for the rotary switches. The test | |
| begins with the rotary switch imediately to | |
| the left of the Cycle Selection Knob. | |
| Rotate the switch in either direction. The | |
| LED’s illuminate around the bottom of the | |
| Cycle Selection Knob for each switch | |
|
| position. |
| NOTE: Any attempt to move a knob or | |
|
| switch other than the one being |
|
| tested results in a chirp sound. |
| Press the Cycle Selection Knob. The test | |
| continues with the switch immediately to | |
| the left of the previous switch tested. | |
| Repeat rotating the switch and monitoring | |
| the LED’s around the bottom of the Cycle | |
X | Selection Knob. Continue pressing the | |
Cycle Selection Knob for each switch | ||
tested right to left untill all rotary switches | ||
| are tested. | |
NOTE: | included in this test. | |
|
| The Water Level Switch is not |
| • After the last rotary switch is tested the | |
| next time the Cycle Selection Knob is | |
| pressed the test will continue with the | |
| rocker switches. Continue pressing | |
| the Cycle Selection Knob and testing | |
| switches until the last switch is tested. | |
| When all switches have been tested | |
| the “Complete” LED will illuminate. | |
SERVICE CYCLE
Enter Service Mode then set Cycle Selection Knob to
“Regular” and press knob.
• Fill and Wash LED’s illuminate. Hot water fill.
• Press knob Fill and Rinse LED’s illuminate. Cold water fill.
• Press knob Fill, Wash, and Rinse LED’s illuminate. Selected wash temperature fill.
• Press knob Wash LED illuminates. Slow agitation.
• Press knob Wash LED blinking. Fast agitation.
• Press knob Spin LED illuminates. Slow spin.
• Press knob Spin LED blinking. Fast spin.
• Press Knob Complete LED illuminates.
• Press knob exit back to Service Mode.
NOTE: Fills are skipped if Pressure Switch is satisfied. Press knob until Pause LED begins blinking to pause cycle.
12 | 16026502 | ©2005 Maytag Services |
