Whirlpool ED20TWXDN02 manual Theicemakerisnotproducingice, Theicemakerisproduqnctoolittleice

THEICEMAKERISNOTPRODUCINGICE

Check if...

The freezer temperature is not cold enough to produce ice.

The ice maker arm is in the “OFF” (up) position.

The water line shut-off valve to the refrigerator is not turned on.

An ice cube is jammed in the ejector arm.

The ice maker mold has no water in it or no ice has been produced.

Then...

See “Setting the controls” on page 12.

Lower arm to the “ON” (down) position. See “Using the automatic ice maker” on page 18.

Turn on the water valve. See “Attaching the ice maker to a water supply” on pages 9-l 1. If not due to any of the above, there may be a problem with the water line. Contact the Consumer Assistance Center at 1-800-253-l 301.

Remove the ice from the ejector arm with a plastic utensil. See page 18 for ejector arm location.

Check to see if your refrigerator has been connected to your home water supply and the supply shut-off valve is turned on. See “Attaching the ice maker to a water supply” on pages 9-l 1.

THEICEMAKERISPRODUQNCTOOLITTLEICE

Check if...

The ice maker has just been installed.

A large amount of ice has just been removed.

The controls are not set correctly.

The water shut-off valve is not turned completely on.

There is a water filter installed on the refrigerator. This filter may be clogged or installed incorrectly.

Then...

Wait 72 hours for full ice production to begin. Once your refrigerator is cooled down, the ice maker should begin producing 70-120 cubes every 24 hours.

Allow 24 hours for ice maker to restock.

See “Setting the controls” on page 12.

Turn valve on fully. See “Attaching the ice maker to a water supply” on pages 9- 11.

First, check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging IS not a problem, call the Consumer Assistance Center at 1-800-253-l 301.

32

WITH QUESTIONS OR COMMENTS